in-lite CURV, Manual

Page: 9 / 20

EN
Connecting the fixture to 100-240 V
If you want to connect the fixture to a 100-240 V power source, you
must use the separately available internal transformer. Your dealer
can advise you about this. The appliance should only be connected to
a 100-240 V power source by an authorised installer.
Step 1
Mark the position of the three attachment holes and the cable hole (A)
in the wall plate on the wall. Make a hole for the cable of at least 13
mm at the location of the cable hole. Attach the wall plate to the sur-
face using the screws supplied and plugs if necessary. (Fig. 1)
Step 2
Position the transformer in the fixture and then fix it in place using the
supplied screw. Make sure that you place the screw in the opening
with the metal ring (safety earthing) on the side of the 100-240 V power
cable. (Fig. 1a)
Step 3
Connect the 100-240 V power cable from the transformer to the con-
necting block (C) in the wall plate. (Fig. 1b)
Step 4
Connect the internal transformer to the fixture by connecting the mini-
connector. (Fig. 1b and Fig. 4)
Step 5
The appliance should only be connected to a 100-240 V power source
by an authorised installer. See the manual that accompanies the inter-
nal transformer.
Step 6
Ensure that the two clamps for the covering plate (B) are free of cable.
Then slide the covering plate over the wall plate until it clicks into
place. (Fig. 2)
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.
Important!
Before starting maintenance switch off the power.