EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
When mounting the fixture you can choose to use the transparant or
the diffuse lens.
General Installation Guideline
During installation, make sure that all components are easily
accessible for replacement.
Step 1
Remove the Torx screw (A). (Fig. 1a) Remove the cap of the fixture by
turning in the direction of the arrow. (Fig. 1b) Create a hole measuring
at least Ø 13 mm in the wall so the wire can be inserted. Do this at a
position which will later be covered by the top half of the fixture. (Fig.
2) Use the accompanying screws (B) to mount the fixture’s assembly
plate to the wall. (Fig. 3)
Step 2
Re-attach the cap of the fixture to the assembly plate. Tighten the Torx
screw.
Step 3
Join the Easy-Lock connector to the main cable. (Fig. 4)
a. There are two cable ducts. The duct with the narrowest slot is suit-
able for the 14/2 and 10/2 main cable. When using the old (thick)
10/2 cable, you should use the duct with the wide slot.
b. Clamp the correct cable duct on top of the main cable. There
should be no space left between the cable and the duct.
c. Place the cable duct (with the cable at the bottom) in the Easy-
Lock connector.
d. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 4
Connect the main cable to the fixture by connecting the mini-
connector. (Fig. 5)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 3 and 4. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.
