in-lite ACE CORTEN, Manual

Page: 4 / 8

EN
Contents
1x ACE ( DARK/WHITE/CORTEN ) 12 V / 3 W
Dimensions 86x78x205mm (lxwxh)
1x ground stake
1x Easy-Lock
2x screws
2x plugs
1x Torx key
Material
Aluminium housing
High quality plastic lens
Please read the following instructions before installing. You are
advised to keep these installation instructions in a safe place.
Use
Above-ground lighting for use in gardens, or as lighting for
highlighting paths, patios or driveways.
Lamp
The fixture is equipped with a high-quality LED lamp. These lamps
have a long life and a high light output and their power consumption
and the heat produced are extremely low.
Important!
Never connect the low-voltage cable directly to a 100-240 V power
source. It is only suitable for use in combination with a 12 V low-voltage
system. This product should only be used within the in-lite system. Use
of products other than those made by in-lite will invalidate the warranty.
Enjoy the lighting in your yard.
EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
General Installation Guideline
During installation, make sure that all components are easily
accessible for replacement.
Step 1
The fixture can be mounted on a hard surface using the screws sup-
pliedor in soft surface using the ground stake supplied. The ground
stake is easily fixed by screwing it in the underside of the base of the
fixture.
When using on hard surfaces, first remove the base of the fixture by
loosening the Torx screw. (Fig. 1) Then fix the base to the surface using
the accompany screws and possibly appropriate plugs. (Fig. 2) Place
the fixture back on the base and tighten the Torx screw once again.
Step 2
Join the Easy-Lock connector to the main cable. (Fig. 3)
a. There are two cable ducts. The duct with the narrowest slot is suit-
able for the 14/2 and 10/2 main cable. When using the old (thick)
10/2 cable, you should use the duct with the wide slot.
b. Clamp the correct cable duct on top of the main cable. There
should be no space left between the cable and the duct.
c. Place the cable duct (with the cable at the bottom) in the Easy-
Lock connector.
d. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 3
Connect the main cable to the fixture by connecting the mini-
connector. (Fig. 4)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 2 and 3. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.