IMT TH36K164, Manual

Page: 23 / 135

Chapter 3 Installation 21
Valve Bank Installation
When the Tirehand has a valve bank, connect the valve bank to the forklift or loader hydraulic
system using the hydraulic pressure and return line from the forklift or loader
1 Install the Tirehand on the loader or forklift, connecting the suction and return lines from the
forklift or loader to the tirehand valve bank. See the hydraulic layout drawing in the parts
manual for hydraulic information for a valve bank installation.
2 Check lubrication points for adequate lubrication.
3 Operate the forklift or loader to check for vertical obstructions. Add stop blocks, if needed, to
prevent the Tirehand from contacting the carrier vehicle.
TESTING
1 Raise the Tirehand to provide adequate clearance for operating all Tirehand functions.
Operate all Tirehand functions and check for leaks.
2 Test the unit at rated capacity. Note any points of instability. Add counterweights if needed.
If the carrier vehicle is articulating, make certain that steering of the vehicle is not hindered by the
routing of the hydraulic hoses. Check for wear points and re-route if needed.
NOTE
If the tirehand operation is erratic, purge air
from the hydraulic system.
WARNING
Avoid serious injury! Keep clear of all pinch
points while operating this unit.
Courtesy of Crane.Market