IMS 8072A, Instruction Manual

Page: 10 / 17

165910 Dew Point Meter 8072A Manual
9
June 2014
Maintenance and Adjustments
IMS Company offers a maintenance and calibration service for
the 8072A. This service should be performed annually,
especially if you are an quality certified company. During the
calibration service most common parts are checked.
Alternatively, most wearable parts can be replaced by the user
if you are not taking advantage of the calibration service.
To access the serviceable parts inside the monitor, the 8072A
panel must be removed from the carrying case.
Monitor Disassembly and Assembly
WARNING: Unplug the 8072A from power before disassembly.
Even with the power switch off, voltages are present inside the
unit.
Slide the sample tubing off of the front panel elbow.
Use a screwdriver to remove the 5 screws along the perimeter
of the panel holding it in the case. Use the sample tubing elbow
to help lift the panel straight up and out of the case.
When re-assembling the panel into the case, make sure sensor
cable wires are tucked in and not binding under the panel as
you lower it into the case.
Install the 5 mounting screws, taking care not to cross thread
the screws as you proceed. The screws only need to be snug to
the panel, do not overtighten!