Imron Corporation 15375 Barranca Pkwy, Suite B-106
Irvine, CA 92618 Phone 949-341-0947 Fax 949-341-0949
INTEGRATED SYSTEM 2000
SO-16 OUTPUT PROCESSOR
System Control Processor
4. Inputs for Cabinet Tamper/Power Fault:
Input CT and input BA are typically used for monitoring cabinet tamper and power failure with normally
closed contacts. These two inputs are for contact closure monitoring only, and do not use EOL
resistor(s). If these inputs are not used, install a short piece of wire at the input to indicated safe
condition.
5. Relay Outputs:
The following show typical use of the relay outputs. DC source is recommended whenever it is possible.
Transient clamping must be provided to protect the contact and to reduce EMI emission. Use sufficiently
large wires for the load current to avoid voltage loss.
6. DIP Switch Usage:
Switches 1 to 5 select the devices communication address. Switches 6 to 7 select the communication
baud rate. Communication on the RS-485 serial port is asynchronous, half-duplex with 1 start bit, 8 data
bits and 1 stop bit.
