line voltage you are connecting to is not higher than that stated on the decal or
rear panel of the fixture.
Before the first time to use it, Please check whether the damage in transit, if
happen damages in transit, please do not use this lamp, and please asap
contact distributors or manufacturers.
Please don't install the lamp in the ordinary combustible material on the
surface. Lamp should be installed in the well ventilated place, and the distance
of the wall to keep it over 10 cm, at the same time, please check the fan hole
was clear.
Do not use lamp direct project in flammable objects, lamp and the radiation
of the distance between the objects please keep it over 12 m.
Do not use direct lamp project light source , to avoid damage the eyes.
Before installation, please make sure your use power supply voltage and
marked voltage
Note: before any install, maintain and clean lamp, please confirm cut off the
power supply.
2. Introduction
2.1 Features
*Light source:1pcs 90W white LED
*Electronic dimmer 0~100%
*Fan Cooling /Forced convection
*Pan movement:540
°
*Tilt movement:270
°
*Pan/Tilt resolution:8-16bit
*Prism rotating 3-facet prism
*Focus:linear focus from close to far
*1 fixed gobo wheel: 8gobos plus blank
*1 rotated gobo wheel: 6gobos plus blank,gobo rotating 360
°
*1 color wheel:7colors plus white
*Strobe:0-16Hz, from slow to fast, adjusting
*Control mode:Auto, sound active , DMX512
*DMX channel:15CH
* LCD display
2.2 DMX channel
3. Setup
Disconnect the power cord before replacing a fuse and always replace with the
same type fuse.
3.1 Fuse replacement
With a flat head screwdriver wedge the fuse hold out of its housing. Remove