Slimline 35 Shower Tray
Installation Guide for concrete floors
SHOWERING FOR THE CARE MARKET
Page 5
2
Place the tray in the desired location and mark position of
shower trap. Then remove the tray.
Measure from outer edges
of the tray to the centre of the drain . Use these dimensions to
position the centre of the trap.
3
Remove enough concrete for the installation of the waste pipe
and shower trap.
Use extreme care whilst cutting the floor as
there may be hidden pipes and cables.
4
Position the trap centre in previously measured location
(stage 2)
,
then connect it to the waste pipe as shown. Remove internal parts
of the trap and place to one side, as they will be required later.
5
Lay a weak sand cement mix in the excavated hole and around
the waste pipe and trap.
Ensure the mix is fairly dry.
Follow steps 6-12 (installation guide for wooden floors) to
complete the installation of Slimline 35 Shower Tray
1
Determine which corner the tray is to be fitted into. This will
establish which edges the fabric tile upstand will be
attached to.
Check if floor is level. If it is not, this will need to be
corrected before continuing with the installation
