Slimline 35 Shower Tray
Installation Guide for wooden floors
SHOWERING FOR THE CARE MARKET
Page 3
1
Determine which corner the tray is to be fitted into. This will
establish which edges the fabric tile upstand will be
attached to.
Check if floor is level. If it is not, this will need to be
corrected before continuing with the installation
2
Place the tray in the desired location and mark position of
shower trap. Then remove the tray.
Measure from outer edges
of the tray to the centre of the drain . Use these dimensions to
position the centre of the trap.
3
Using suitable saw, remove enough floor boards to receive the
shower trap and any drainage pipework.
Use extreme care whilst
cutting the floor as there may be hidden pipes and cables.
4
Position the trap centre in previously measured location
(stage 2)
,
then connect it to the waste pipe as shown. Remove internal parts
of the trap and place to one side, as they will be required later.
5
Replace floor boards and cut around the trap.
6
Cut required length of the fabric tile upstand.
