Impex MWM-981, Owner'S Manual, Page: 7 / 24

ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and
Allen Wrenches. NOTE: It is strongly recommended that this machine to be
assembled by two or more people to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Insert the two Guide Rods (#11) through Rubber Bumpers and into the holes on
the Rear Stabilizer. Secure each Guide Rod with one M10 x 1” Allen Bolt (#64) and

¾” Washer (#73) from the bottom.
The Guide Rods has holes on the rod to
lock the weight stack when not in use. The shorter end of the guide rod with
the lock hole will need to be pointed downwards towards the Rear Stabilizer.
B.)
Do not tighten all Nuts and Bolts starting from this procedure until instructed
to do so.
C.) Attach two Rubber Bumpers (#28) onto the holes onto the Guide Rods.
D.) Attach the Base Frame (#3) to the Rear Stabilizer. Secure them with two M10 x 4”
Carriage Bolts (#59), one U-shaped Bracket (#20), two Ø ¾” Washers (#73), and
two M10 Aircraft Nuts (#70).
E.) Attach the Vertical Frame (#4) onto the Base Frame. Secure them with two M10 x
2 3/8” Carriage Bolts (#58), one 1 ¾” x 4 ¾” Bracket (#18), two Ø ¾” Washers
(#73), and two M10 Aircraft Nuts (#70).
F.) Slide 11 Weight Plates (#50) onto the Guide Rods.
Make sure the deep grooves
on the Weight Plates all face the back of the machine and downward
. Align
the holes on the Weight Plates. Insert a Selector Rod (#21) through the center
hole. Slide the Selector Stem (#51) onto the Guide Rods.
G.) Use a Weight Selector Pin (#44) to select the number of Weight Plates to exercise.
Attach the ring on Weight Selector Pin’s cable onto the Selector Rod.
Note: Each
Weight Plate weights approximately 10 lbs. Please refer to the Weight
Resistance Chart in page 25.
H.) Attach the Seat Support (#5) to the Vertical Frame. Secure it with two M10 x 2 3/8”
Carriage Bolts (#58), one 1 ¾” x 4 ¾” Bracket (#18), two Ø ¾” Washers (#73), and
two M10 Aircraft Nuts (#70).
I.) Attach the Vertical Seat Support (#6) to Seat Support and Base Frame. Secure
each end of Vertical Seat Support with two M10 x 1” Allen Bolts (#64) and two Ø
¾” Washers (#73).
6