I-Control manual
page 5
Note:
When no keys are pressed for a while, the I-Control will return to the main menu.
Main screen
The main screen of the I-Control
The top line indicates the current time.
When there is an alarm detection, a blinking alarm will appear in the upper right corner.
On the following lines the status of the I-Control, the number of flushes today, the amount of flushed liters today
and the current day number are shown.
The status may display the following modes:
Man.off
(Manual off) The I-Control is manually turned off and there will be no flushing until the I-Control is
manually switched on again.
Clk.off
(Clock off) The I-Control is automatically turned off by the start and stop time, such as during the night
hours.
Tmp.off
(Ttemporarily off) The I-Control is blocked for a set time, such as when medicines have been added to
the drinking water. Flushing is, therefore, undesirable for a certain period of time. After this time
period, flushing will resume automatically.
Man.on
(Manual flushing) One valve is flushed manually.
Man.all
(Manual flushing all)
All valves are flushed manually.
Time on
(Flushing time) The flushing starts
automatically at a set start time.
Temp.on
(Flushing temperature) Flushing starts by the temperature control when the temperature of the water
becomes too high.
Dirt.on
(Flushing dirt) The flushing starts by the pollution control when the drinking water becomes too
polluted.
Waiting
(Waiting) The I-Control is in the waiting mode for a possible next flushing cycle.
Delay
(Delay) The I-Control is waiting in the delay time. After each flushing cycle, there is no flushing during
an set delay time.
Init.
(Initialization) The I-Control has just started and is in the initialization phase. This phase is used for
temperature and sensor readings before the control process begins and takes about one minute.
Filling
(One-time filling) All drinking lines are filled with a set amount of water.
Next to the status, under the head
No
, the number of flushings today is shown.
Ltr
indicates the amount of liters
flushed today;
Day
indicates the day number used in the course of a curve.
The positions of the valves are indicated on the last line. Under each valve number a light flashes when the
corresponding valve is active. With this done, the light will remain on without flashing.
Registration screens
By using the
and
key, the main screen can be reached from the registration screen. The registration
screen appears as follows, for example.
15:10
Status No Ltr Day
Man.off 1 12 5
1 2 3 4 5 6 7 8 9 10
o o o o o o o o o o
< Regis. day >
Flush temp
0
Flush dirty
0
Flush time
1
Total flush
1
Liters/day
34L
