Flush Mount Installation Details:
CABINET:
Be sure cabinet bottom is level, side to
side and front to rear.
For the “SD” units prepare cabinet by cutting an
8” x 8” hole in bottom, 3/4” from wall and on
Center line.
For the “PS1” units prepare the cabinet by
cutting a 10 3/8” (D) x 20 1/4” (W) hole in the
bottom, 1/2” from wall and center line.
Shelves and top to be cut to clear 7” round pipe.
Also, cut holes for electrical wires.
NOTE:
Bolts, washers and nuts supplied.
Remove the Drawer before positioning the hood
under the cabinet. *See next page on how to
remove.
Position hood against cabinet bottom and against
wall. Mark the underside of cabinet through
each key-hole for location of each bolt hole.
Drill 3/16” holes through cabinet bottom. Insert
bolts with small washer under head of bolt
through cabinet bottom from inside the cabinet.
Again, position hood under cabinet with bolts
through key-holes. Starting with front key-holes,
place large washer on bolt, attach the wing-nut to
bolt, secure both front wing-nuts. Push hood
back against wall, secure large washer and the
wing-nuts on rear bolts.
Re-install the pull out drawer.
Connect duct and tape all joints.
Replace Filters
ELECTRICAL:
Stub enough wire into cabinet to reach in front of vent pipe.
Remove Black Tape that holds dampers in closed position.
Enter the cabinet 3 1/4” left of center for (SD unit) or 2 1/4” for the (PS1 unit).
Remove splice box cover before mounting the hood.
After hood is mounted attach house wires to leads in hood.
Secure locknut to conduit and check wiring for compliance with all local codes.
Replace splice box cover.
Standard Duct size is 7” Round. Increase CFM by increasing duct size:
7” to 8” transitions to increase CFM by 20%. (Available on PS1 models only)
Models are indicated with an
8
for 8” duct.
Example: G3036PS1-8 or 3036PS1-8
6"
17-1/4"
4-
1/
4"
7"
3/
4"
9-1
/8"
11
-3/4
"
4-
1/
16"
30
",
36
",
42"
or
4
8"
7/8"
1-
1/
2"
3-
1/
2"
6"
21-3/4"
4-
1/
4"
9-1
/8"
11
-3/4
"
7/8"
1-
1/
8"
1-3
/4"
4-
1/
16
"
30
",
36
" o
r 4
2"
1/
2"
7"
1/2"
4-1
/4"
10
-1/8
"
20
"
5"
1-3
/4”
1-3
/4”
