background image

 

 

 
 
 
 
 
 

Read Before Starting Installation! 

 

Inspect your range hood prior to installing! 

 Any cosmetic defects must be reported to us prior to installation. 

Once this hood is installed, ICP will NOT accept any responsibility 

 for any cosmetic blemishes, scratches or dents in the Canopy. 

Save all original packaging if you wish to return for any reason! 

 

FIRST: 

Check your local building and electrical codes.   

 

WARNING: 

 

To reduce the risk of fire or electrical shock, Do Not use any two speed motor units with a Solid State 
control devise. 

 

CAUTION:  

To reduce the risk of fire or personal injury and to properly exhaust air, be sure to duct air  to the outside.  

DO 

NOT

 vent exhaust air into spaces within wall, attics, ceilings, crawl spaces or garages.  When venting to the      

outside make duct run as short and straight as possible.  Avoid using elbows if at all possible.  If  elbows are used, 
we recommend that the first elbow is 24” from vent opening on the hood (minimum of 12”)and at least 24”       
between it and the next elbow.  We strongly recommend no more then two 90 degree elbows in any duct run.     

No Performance Warranty when used above BBQ Style Grills.      

 

 

DO NOT 

use duct pipe smaller than the outlet duct opening on the hood, this will reduce performance and void 

the warranty.  

DO NOT 

use flex ducting.  Also, use either a Roof Cap or Wall Cap to end run.  Be sure that all 

joints are taped securely in place.   
It is essential to have the proper distance between the bottom of the range hood and the cooking surface below.  In 
most cases the cooking appliance manufacturers specifications will establish the fire safe  
minimum distance required, although there are other factors to consider: 



Local Building Codes 



Cross directional air movements ie: open windows,  air conditioning/heating outlets, cooling fans, etc. 



Overall size of the cooking appliance and surrounding countertop surfaces. 



Range hood model selected. 

 

*REDUCING duct size will VOID Warranty. 

 
Minimum distance between cooking surface and the bottom of the hood is 30” and 36” is the maximum distance.  
Keep in mind, increasing the distance will decrease the performance.  

 

 

 
 
 
 
 
 

 

Summary of Contents for G3000 SERIES








Reviews: