Imperial Cal Products, Inc.
No-Vent Kit Installation Details:
MODELS
NV30, NV36, NV42
NOTE:
The Charcoal Filters in the NV Kit may not be washed and must be replaced on a regular basis.
How often depends on the amount of cooking done and the amount of grease and odor collected. Once the
Charcoal Filters is saturated it will no longer filter out odors.
The aluminum filters in the hood can be washed and will last for years with proper care. Be sure to clean
them on a regular basis.
1. Remove Back Draft Damper blades from the hood if they are in position.
2. Line up NV Brackets on the top of the hood. Positioning them between mounting the holes and the
edge of hood. Mark and drill 1/16” holes. Install brackets using #8 screws.
3. Drill four 3/16” holes into cabinet matching the location of the mounting holes on the NV Kit. Drill out
the electrical hole in the cabinet to line up with 7/8” hole in the NV Kit.
4. Check to see if the hood has mounting holes to line up with the NV Kit, if there are no holes drill four
to line up with the NV Kit Hood Mounting holes.
5. Remove front grill from the NV Kit and the Charcoal Filter. Install NV Kit to the cabinet with four
#10 screws.
6. Remove the Filters from the hood.
7. Install Electrical using 90 degree cable connector. Bring electrical through hole in the cabinet.
8. Slide hood onto NV Kit using brackets on the hood.
9. Install long screws (with washers) through the cabinet, NV Kit and the hood and secure with the wing
nuts on the inside of the hood.
10. Replace the Charcoal filter in the NV Kit. Replace the front grill on the NV Kit.
11. Replace the filters in the hood.
No Vent Kit showing key-hole installation
No Vent Kit shown being used with the G3000SD2
Note: Back Draft Dampers have been removed!
