C- Safety flap
is open
C- Close the
safety flap
Contact an authorised retailer if none of the problems illustrated above are found
(see back of warranty form).
B- Switch is in
position "O"
B- Place the switch to
position "I" or "II"
7
USER MAINTENANCE INSTRUCTIONS
BEFORE EACH USE
Cleaning is the only operation normally required.
Make sure the machine is not plugged in and that the switch is in "
O
" position. Carefully
clean the machine and the accessories used with a dry cloth or soft brush.
Place the machine on a flat stable surface and start the motor, to complete the cleaning ope-
ration by passing a small piece of dough between the turning rollers as shown in fig. 4. This
will eliminate any traces of dust.
Carry out this operation with all the accessories that are to be used (page 6).
The dough used for this operation must be obviously thrown away.
Never use
jets of water or detergent to clean the machine and the accessories.
Never wash
the machine parts or accessories in a dishwasher.
AFTER EACH USE
Press the switch to "O" position and remove the plug from the socket.
Carefully clean the machine and the accessories with a dry cloth or a soft brush.
Never remove residual pasta or flour using sharp tools or cutlery.
NEVER WASH ANY MACHINE PART OR ACCESSORIES IN A DISHWASHER.
Check that all parts are perfectly dry before putting them away after use.
Carry out the following checks if the machine does not work.
TROUBLESHOOTING
IF THE MACHINE DOES NOT WORK
PROBLEM
PROBABLE CAUSE
SOLUTION
The machine either does not
start or stops suddenly
A- The machine is not
plugged in or is plugged
in incorrectly
A- Plug the machine in
correctly
