8
FRONT PANEL OVERVIEW:
The following diagram and legend shows the functions of the front operating panel . Some functions are
only available on select models .
When you push the button to change operation modes, the unit will make a beep sound to indicate that it
is changing modes .
1) Pump Button
Press to activate continuous pump drainage mode.
2) Filter Button
The check filter indicator is a feature to remind you clean
the air filter for more efficient operation. The filter light will
illuminate after 250 hours of operation. Toreset after cleaning
the filter, press the filter button and the light will go off.
3) Fan Speed Button
Control fan speed. Press to select either high or normal fan
speeds. Set the fan speed to high for maximum moisture
removal. When the humidity is reduced or quiet operation is
preferred, set the fan speed to normal.
4) Power Button
Turns the unit on and off.
5/7) Up (+) & Down (–) Buttons
The relative humidity (RH) can be set within a range of 35%
to 85% in 5% increments. For drier air, press the pad and set a
lower percentage value (%). For damper air, press the pad and
set a higher percentage value (%).
6) Timer Button
Activate the unit for a set period of time, increased and
decreased using the + and – buttons
DISPLAY:
Shows the set % humidity level from 35% to 85% or auto start/stop time (0~24) while setting, then shows the ac-
tual (5% accuracy) room % humidity level in a range of 30% RH (Relative Humidity) to 90%RH (Relative Humidity) .
ERROR CODES AND PROTECTION CODES:
AS) Humidity sensor error—Unplug the unit and plug it back in . If error repeats, call for service .
ES) Temperature sensor error—Unplug the unit and plug it back in . If error repeats, call for service .
P2) Reservoir is full or reservoir is not seated correctly—Empty the reservoir and replace it in the right position .
EC) Unit malfuction—Please make sure whether the enviroment temperature is suitable for the stated temperature in the
manual or not . If not, please operate the unit under the stated temperature . If the enviroment temperature is suitable for the
stated temperature, please call for service .
E3) Unit malfuction—unplug the unit and plug it back in . If the error persists, contact technical support immediately .
Eb) The condensor collection bucket is in the wrong position . Remove the bucket and reposition it correctly .
