4
email: [email protected], Website: www.impcollc.com
Electrical wiring on your unit is not required as the unit has
been wired at the factory. For your future reference, the wiring
diagram in Figure 7 shows rocker switches, two-speed motor,
capacitor and pump.
The cooling pads should be replaced with fresh aspen fiber
at least once a year, at the beginning of each cooling season.
The need to change pads varies with locality and how much
dust, alkali and other foreign matter accumulates in pads. If
cooling efficiency is impaired, it may be desirable to change
pads several times during a cooling season.
Replacement Instructions:
To remove pad assemblies from the unit, lift up, pull out and
then down. Lay the metal side down on a flat surface and
remove the pad retainers. The aspen filters can now be removed.
Rinse off pad assembly, then install new aspen filter and retainer.
Replacement filter pads are available at your cooler dealer.
ELECTRICAL
COOLING PAD REPLACEMENT
GREEN (GROUND WIRE)
GREEN (GROUND WIRE)
GREEN (GROUND WIRE)
GREEN (GROUND WIRE)
NEUTRAL (WHITE WIRE)
HOT (BLACK WIRE)
HOT HIGH SPEED (BLACK WIRE)
HOT LOW SPEED (RED WIRE)
NEUTRAL (WHITE WIRE)
NEUTRAL (WHITE WIRE)
MOTOR
WIRE NUT
PLUG
PUMP
PUMP SWITCH
GROUND SCREWS (ISOLATED CORD GROUND)
WIRING DIAGRAM
MOTOR SWITCH
HOT (BLACK WIRE)
Dimensions (in)
Water Capacity
Shipping
Weight
A
B
C
D
22
19
23.6
29
4.5 Gallons
65 lb
SPECIFICATIONS AND DIMENSIONS
Motor
Frequency
Volts
Current
1/8 HP
60 Hz
120 V~
3.6 A
Picture 7
Picture 8
Picture 9
Picture 10
Figure 7
