Impco Mobile Symphony SPM20 Owner'S Manual Download Page 2

email: [email protected], Website: www.impcollc.com

1

WARNINGS AND SAFETY RULES

!

INTRODUCTION

Evaporative cooling works on the principle of heat absorption

by moisture evaporation. Simply put, heat is removed from the

air as water evaporates. You feel this principle in action when

you step out of a swimming pool or shower; you feel immedi-

ately cooler as water evaporates from the surface of your skin.

Your evaporative cooler works on the same principle. Hot out-

side air is pulled through water-saturated pads, where the air is

cooled by evaporation and then discharged from the cooler.

WARNING…

To reduce the risk of electric shock, fire or injury:

Read instructions and labels carefully.

Always unplug the electric cord to your cooler before

you work on the cooler.

Your cooler will run on 120 Volt AC, 60 Hz (cycle)

current only.

Plug into three-prong grounded GFCI protected

electrical receptacle only.

Do not operate if plug or cord are damaged in any way.

Do not step on or roll over power cord with heavy or

sharp objects.

Do not operate unit unless all panels are securely in

place.

Remove the plug from the electrical receptacle by

pulling on the plug and not the cord.

Test the GFCI receptacle or breaker monthly to ensure

it is functioning properly.

Do not operate near open containers of flammable

liquids or gases.

Never wash your cooler cabinet with a garden hose;

water may harm the motor and pump.

If the unit is damaged or it malfunctions, do not contin-

ue to operate it. Refer to the warranty or troubleshooting

section at www.impcollc.com

Other Symphony Units

Hi Cool

R28RTE

Summary of Contents for Mobile Symphony SPM20









Reviews: