6
Wall mounting
Never mount the unit on a wet wall, the monitor is intended for indoor use only
disconnect the power before wall mounting the monitor
The monitor has a molded cut-out on the reverse side, this is used for single point mounting on a
screw protruding from the wall, simply hook the monitor over the screw making sure it’s latched
on properly, if extra stability is required two further through hole mountings are available behind
the lower cover.
General information
Large Liquid crystal display:
This indicates detected gas concentration.
Observe display for gas level detected.
Alarm LED:
This indicates a level above the pre-set alarm level has been reached
.
Alarm sounder:
This activates when the alarm state is reached giving a high pitched
continuous tone.
Sensor malfunction LED:
This alerts the user that a variation away from normal parameters
has been detected: the monitor may continue to function if this occurs please contact your
supplier for service.
Operation
Following an initial warmup period of 3 minutes, providing the sensor malfunction warning is not
indicating a fault, the instrument is ready for use.
Other than periodical observation of the display, no other action is necessary by the user, it is
important to remember that no alarm is possible in the event of a power failure.
Under no circumstances should the monitor be used if the Sensor malfunction light is activated,
in the case of a sensor malfunction discontinue use of the instrument and contact your supplier.
