there is no need to reset the Timer to continue the test. The machine can be
restarted with the Start/Stop Switch in the normal manner. The machine will
continue its test until the pre-set time is reached.
9.8
The Feeder Units must be set with a gap between the bottom of the Hopper
and the surface of the belt to allow free rotation. If necessary, adjustment is
carried out using the 4 M5 Slotted Screws. The normal factory setting is
0.25/0.38mm.
9.9
The Motor Switch has a “no volt” release trip for safety (i.e. the motor needs to
be restarted by depressing the ‘START’ button).
9.10 When the Road Wheel is removed, ensure that it is replaced the correct way
round. The front of the wheel is either stamped “FRONT” or marked by a
“Yellow Disc” on the side facing outwards.
9.11 Not In Use. When the machine is not in use, lightly oil the Main Spindle and
Road Wheel Bore. Remove the Tyred Wheel(s) and store appropriately.
9.12 Further maintenance information is outlined in BS EN 1097-8: 1999 Annex C.
NOTE : The machine will not start until the removable front
cover is in place, and the timer has been pre-set.
- 12 -
Summary of Contents for AG 139
Page 16: ... 14 ...
