Step 4: Insert support bar and fit cover
a.
On the inside of the cover locate the pockets (6) total. Slide in one “B” pipe into each pocket. This is the last of
the “B” pipe. Adjust the cover slightly to make sure the support bars “B” pipe are even in height on each side of
the frame.
b.
Starting on one side, working front to back, attach (2) of the “F” Single clamp brackets around the leg “B” pipe
and to the horizontal support bar “B” pipe using (1) of the “I” Nut and Bolt. Be sure that the nut is facing inside
the frame so that it cannot wear the cover. Do not completely tighten bolt yet.
c.
Next attached the double clamp “G” around the center leg pipe “B” and two of the horizontal “B” support bars
using (2) of the “I” Nuts and Bolts. Repeat step B on the third leg and assemble the opposite side.
d.
Once all six “B” support bars are connected using the single and double sided clamps push down on each side to
even the cover and aligning all the bars so that they are even and tighten the nuts.
