Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document. © 2016 Norgren Automation Solutions, LLC
07
User Instruction for PGS10H Series Gripper
E. Installing a Side Plate
1.
With the
Side Plate
at 45°, align pins of side plate with slots of frame. Slide pins into slot. When pins are fully seated,
rotate side plate and slide down onto frame.
11/16
14469UI REL: 002
2.
Add Schnorr washer to M5 X 12mm SHCS. Insert through side plate and into frame. Tighten M5 SHCS to
72in-lb
.
F. Installing an Indirect Sensor
1.
To install an
Indirect Sensor
, apply a liberal amount of high temperature grease to brass bushing prongs inside
sensor. Next, move the brass bushing in the sensor to align with drive rod slot in gripper. This must be done to
correctly install sensor. Make sure the sensor is in the orientation where the cable is pointing to the rear of the gripper.
Bushing
prongs
Drive rod slot
2.
Apply Loctite 262 or equivalent to the three blind M4 tapped holes.
