IMG STAGE LINE TWIST-5LED, Instruction Manual

Page: 8 / 24

7
Backside
Fig. 2
3 4 5 6
3)
IEC power connector
4) Fuse F2A 250V
5) DMX signal connector (IN) 3-pin
6) DMX signal connector (OUT) 3-pin
Installation
Remove all packing materials from the
TWIST-5LED
Spot . Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. The device can be music-controlled by its built-in
microphone.