IMG BRASIL BIMG METVISA FTE.150, Instruction Manual, Page: 22 / 40

26
When you experience any malfunction or non-compliance, refer your equipment to the
nearest service center. See technical assistance on our website: www.metvisa.com.br
5.3 Prolonged Interruption in Use of Equipment
When leaving the appliance unattended for an extended period of time, unplug it from the
mains, keep the oven door open, and perform a thorough cleaning, including the various accessories. It is
advisable to protect all parts of the equipment with white vaseline or with suitable commercially available
products. You should also protect the equipment from dust by covering it with a nylon or other material.
6. Analysis and Troubleshooting
6.1 Problems, possible causes and solutions
Products with IMG quality are designed with materials and components that guarantee
longer life to your equipment. However, due to natural wear, improper use or lack of maintenance, the
equipment may have irregularities in its operation.
In the following table, you can check possible causes and solutions:
PROBLEMS POSSIBLE CAUSES SOLUTIONS
Equipment will not turn on
Lack of electricity.
Check for power on the network.
Check that the power cord is plugged into a wall outlet.
Voltage different from mains
voltage.
Send the equipment to the nearest authorized service
station or contact the factory.
Miscellaneous electrical
problems (motor / capacitor,
contactor,
wiring, fuse,
electric switch, power cable,
buttons and burned resistor).
Open door.
The door has a safety system that prevents fan
operation and heating if it is open, close the door and
switch on the oven again.
Knob axis does not trigger
electric switch. Send the equipment to the nearest authorized service
station or contact the factory.
Oven does not heat or
hang in the middle of
operation
Lack of electricity.
Check for power on the network.
Check that the power cord is plugged into a wall outlet.
Miscellaneous electrical
problems (motor / capacitor,
contactor,
wiring, fuse,
electric switch, power cable,
buttons and burned resistor).
Enviar o equipamento para posto autorizado mais
próximo ou entre em contato com a fábrica.
Equipment presents
noises
Wiring touching the motor fan.
Send the equipment to the nearest authorized service
station or contact the factory.
Unbalanced fan propellers.
Steam pipe leaning against
fan protection grid.