IMET Spa BS300/60 AFI-E, User Instructions

Page: 25 / 61

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
BS 300/60 AFI-E ED.2010 rev.00
24/61
9.4 - CONTROL DESCRIPTION - .
- Main switch with magnetic and thermic protection. It can be locked and is equipped with device to protect it
against power failures.
- Emergency button: it stops all drivers
– pos.14/RI0439 – to restore them rotate the button to the right
- Control panel with display
– pos.3/RI0439 – (see paragraph KEYBOARD)
Other drivers are located in easily accessible positions:
- hydraulic device to adjust the down-feed speed
– pos.12/RI0439
- device to adjust the general pressure
– pos.1/RI0426
- manual opening/closing of the frontal vice
– pos.10/RI0439
- unlocking of the worktable rotation for miter cutting
– pos.6/RI0439, located on the right side of the turning
table
- taps of the coolant system
– pos.7/RI0439
- locking/unlocking of the mobile forward blade guide
– pos.8/RI0439
- lever and wheel to adjust the cutting length
– pos. 2,4/RI0442
- locking of the feeder vice
– pos.5/RI0442
9.5 - SEMIAUTOMATIC CUTTING SETTING
The original band allows to cut different sections of material, thanks to the variable pitch toothing ( alternate
little teeth with big teeth ), but it is necessary to have the most suitable band for the piece to cut, to get the
best machine performance. So we recommend to read the paragraph BAND CHOICE - for a right use.
Place the material in the vice, leaving 2-3 mm between it and the jaws, necessary for the automatic closing of
the vice. The bar has to be behind the cutting line
. Unlock the emergency button if it’s been pushed -/RI0464-
turn on the hydraulic unit motor by pushing the button CLOSE VICES
– pos.19/RI0055 – and push it a second
time to close the vice.
Verify that the bar is properly clamped by the jaws and that the clamping pressure is suited
– it
doesn’t have to cause a deformation of the material.
The vertical roller
– pos. 11/RI0442 – has to be moved close to the bar to help the feeding.
During the semiautomatic cycle, the feeder covering can be open or closed, since the safety end-
stroke is not active.
Lock the small screw
– 2/RI0468 – located over the main screw, in order to prevent the vice from
opening while the saw is running. Position the forward blade guide
– 8/RO0464 – so that it doesn’t
collide with the bar or the jaws when the sawframe drops.
9.6 - SEMIAUTOMATIC CYCLE
Place the material so it goes over the cutting line, then lock it, select the motor speed , the working, the
coolant delivery and start the cycle with the button START CYCLE- pos.20/dr.RI0055. Adjust the coolant flow