E211101X_rev02_ENG
29/06/2022
22
To unlock the machine, press the "RESET GAS" button. The control unit will try to ignite the gas again. If the ignition
is difficult, and it is necessary to press the "RESET GAS" button several times, please contact the Installer, for the
verification of the gas supply system.
23.
COUNT MANAGEMENT
During the activity of the machine, a counter of working hours is increased and is kept in memory between one
shutdown and the later re-ignition. The Installer can view the number of working hours by accessing a reserved area of
the microprocessor.
24.
SPEED TEMPERATURE COMPENSATION
You can manage the ironing machine so that the speed changes automatically as the temperature changes. The change
changes the speed value within a range of 1% to 20% of the set point value.
Based on the percentage difference between the current value of the temperature and the set one, the speed of the roller
with respect to its set point value is also varied in a directly proportional way and by the same percentage quantity.
This management is optional: if you want to apply it, make a request to the Installer, who will reconfigure the
microprocessor.
25.
WORK CYCLE: CYCLE CONCLUSION
At the end of the work shift, the machine can be stopped by pressing the "STOP" button or by the "COOLING" button
(see relevant paragraph). Please note that the COOLING function is not enabled in machines with steam heating.
ATTENTION!
To stop ironing, make sure that the temperature of the roller is below 80°C. By suspending work at a higher
temperature, burns to the ironing bands can be caused.
At the end of the work cycle and in any case always, when the machine is not in operation, remember to detach
all the power supplies in the following order:
o
gas supply (if any): close the
supply
o
power supply: open, bringing them from position "1" to position "0", the electrical switch(s)
placed on board the
machine. Finally, unplug the power supply from the socket provided by the
Installer.
26.
WORKING CYCLE: TO START A MACHINE WITH FOLDING SYSTEM Wait some seconds for
the software loading, then the below screen will appear:
•
Ironed linen exit: it signals the linen exit direction. Touching this icon, it is possible to enter the menu
for the exit direction change: frontal or rear exit.
•
Folding system management: it signals in green the actual folding configuration.
If the two-side column are light on, it means that the machine is used on two folding independent
line. If the central column is light on, it means that the machine is used on one folding line.
If the line 4a is green coloured, it means that the folding function is not selected.
