Imesa ES7PEE, Operating Instructions Manual

Page: 20 / 28

20
Installation
5. Fit the plastic cups so that the “tags” marked
with arrows are against the front edge or side
edge of the cover and press them firmly onto
the cover. Then break off the remaining tags.
6. Push out the knock-out hole on the back of
the tumble dryer (you must not remove it, just
open it) using a hammer and screwdriver.
7. Push the tumble dryer in under the metal
brackets. At the same time keep the front edge
raised by 10 mm to 20 mm.
8. Lower the tumble dryer’s front feet into the
plastic cups and adjust the tumble dryer to
ensure it is level.
Adjusting the feet
Screw the feet in or out so that the tumble dryer is
both stable and level.
Air evacuation
The air vented from the tumble dryer must be
channelled to an exhaust air duct or an exhaust
outlet in the wall using the supplied vent hose.
Connection to the tumble dryer
The tumble dryer has three options for venting
air: at the back, on the right side and on the left
side. One hole is open when the tumble dryer is
supplied. The other two have covers. The tumble
dryer comes with a connector (1), a plastic band
(2) and a vent hose (3).
1
2
3
Fit the air evacuation system as follows:
1. Slip the vent hose onto the connector and
secure it using the plastic band.
2. Remove the plastic cover if you want to fit the
vent hose to one of the holes other than the
one already open.
3. Insert the connector with the vent hose into the
opening.
4. Place the cover over the open hole.