Imesa ES7PEE, Operating Instructions Manual

Page: 19 / 28

19
Installation
Positioning the tumble dryer
The tumble dryer can be free-standing or in a
stack. Remember that the tumble dryer produces
heat and should therefore not be located in a
room that is too small. If the room is very small,
drying will take longer due to the limited quantity
of air.
WARNING!
• Any electrical installation must be carried out
by qualified professionals.
• The machine must not be installed behind a
lockable door, a sliding door or a door with
hinges on the opposite side to those of the
tumble dryer.
• The tumble dryer's plinth ventilation must not
be blocked by a rug or the like.
NOTE!
To improve ventilation, leave the door to the room
where the tumble dryer is located open.
Freestanding
The tumble dryer can be positioned beside the
washing machine. An air gap of at least 5 mm
must be left between the washing machine and
the tumble dryer.
Stacking
The tumble dryer can be placed on top of a IMESA
washing machine. Use the two foot cups found
in the document bag included with the machine
and the two tip guards attached to the bottom left
corner of the back of the machine.
How to assemble the stack:
1. Remove the two tip guards from the back of
the tumble dryer. Replace the screws that held
the tip guards in place.
2. Undo the two screws indicated on the back of
the washing machine.
3. Secure the anti-tilt device using the screws as
shown in the picture.
4. Attach the plastic cups for fixing the tumble
dryer’s front feet to the washing machine’s
top cover. This is essential, as only when the
tumble dryer’s feet are resting in the plastic
cups can you be sure that the tumble dryer is
correctly positioned on the washing machine.
Break off tag A on the cup fitted on the right-
hand side and tag B on the cup fitted on the
left-hand side. Then remove the paper from
the self-adhesive surface under the plastic
cups.
A
B