3
Chapter 1
1.1
Machine Description
The machine is mainly used in carbonating and mixing of carbonated beverage, such as
lemonade, coke, juice etc carbonated drinks. It is main equipment in the beverage production
line, especially the production of middle and superior quality.
Characteristic:
1)
Advanced chemical industry technology is applied in the machine, the transmission
medium area is large, low resistance loss, high efficiency, simple construction, and the
multistage centrifugal pump which has reliable performance, small noise is applied, this
make the whole machine performance ensure.
2)
High precise needle valve and pneumatically actuated angle valve are separately set up in
the pipe of syrup and water, the mixing rate can be adjusted accurately by the valve, and
syrup and water aren’t flow into each other.
3)
Gas containing can be adjusted conveniently according with the need of beverage gas
containing.
4)
Auto-‐control system is set up in the machine, it has characteristic of coordinate action,
simple construction, production continuum, high automatic degree.
5)
Home position cleaning technological process is set up in this machine, it has reasonable
construction, chemical sterilization, hot sterilization and cleaning with clean water can be
done conveniently. It meets the requirement of food sanitation law.
1.2
Un-‐crating Instructions
During un-‐crating make sure that no physical damage to the outside of the crate has taken
place. Carefully break open the exterior panels to reveal the machine and its working parts.
The machine will be covered in a plastic protective cover. This is to be removed. Make sure
that no parts have been damaged during transport, or fallen off the machine. The machine will
arrive with certain parts dis-‐assembled. These need to be fitted to the machine to resemble
the photos above the machine. The machine is fixed to the wooden palett by four metal
brackets. Remove these brackets and discard or keep for future use. The doors and covers
have been taped closed for safety reasons, these taped parts can now be opened. Surface rust
can take place due to the excessive sea sir during shipping. This will only be surface rust and a
dry cloth should be used to remove this rust residue. The entire machine has bee shipped with
an oil coating on the surface to safeguard the machine from corrosion. This can now be
removed with a very light detergent. The non-‐stainless steel parts should be re-‐oiled to
prevent rusting taking place after cleaning. Do not leave the machine wet.
The machine is top-‐heavy and as such, care should be taken when handling the machine and
removing it from its wooden pallet.
NOTE:
DO NOT HANDLE THE MACHINE ON THE FILM BRACKETS OR ROLLERS. These parts are
critically aligned and should they be bent out of position the film may run off.
