Chapter 2:
Hardware Installation
Installing a
FiberLinX Module
involves the following steps:
1) Configuring the
FiberLinX Module
via its eight-position Dip
switch for the following:
l
Half/Full Duplex setting (data ports only),
l
designating the management traffic port,
l
host/remote or standalone operation;
2) Installation of a
PowerChassis/100-Series
chassis;
3) Installation of the
FiberLinX Module
into the above-mentioned
PowerChassis
; and,
4) Selecting a crossover or pass-through connection for the twisted
pair data port.
Configuring
FiberLinX
Modules
FiberLinX Modules
have an eight-position Dip switch, located at position
S2 (shown below), for configuring the module.
Figure 2.1 Dip Switch Location on
FiberLinX
(default settings shown)
2.1
All manuals and user guides at all-guides.com
