iMartine Vrillo J300, User Manual

Page: 12 / 18

Daily
Maintenance Daily Maintenance
2.Clean the mop, dry the water tank and mop
(Electric-controlled water tank) (Hanging permeate type water tank)
Sensor (clean it regularly)
Clean the sensors by soft mop, include:
1.Clean the sensors along the wall on the right.
2.Three anti-dropping sensors at the bottom of the host.
3.Infrared avoidance sensor in the front of the host.
4.Radar avoidance sensor on the top of the host.
5. Electric shock protector and charging base shrapnel at the
bottom of the host (please cut of the power during cleaning).
6.Signal transmission area of charging base.
Anti-dropping sensor
Sensor (cleaned monthly)
LDS laser ranging sensor
Anti-collision sensor for radar
Anti-collision sensor
Infrared recharging sensor
(Fig.2)
Battery
Upgrade firmware using mobile APP. If new firmware is
detected, upgrade it according to prompt. The battery level
should be
≥ 50%during firmware upgrade, so the machine
should be placed on the charging base.
Firmware upgrade
Upgrade firmware using mobile APP. If new firmware is
detected, upgrade it according to prompt. The battery
level should be
≥ 50% during firmware upgrade, so the
machine should be placed on the charging base.
Signal emission
area Charging base
pins
System reset
Take down the dust box, open the rubber plug and press
Reset key (refer to page 4). Current map will be lost,
and timing, Wi-Fi and personalized settings will be
reserved after reset.
(2 in 1 electric-controlled water tank)
Pull out the dustbin then pure out the water from water tank
Charging contact
(Fig.1 (Fig.3)
18 19