4
Once you’ve turned on your iMARC system, it is now time to install the holders.
Your holders need to be installed on the engraving table during HOLDER SETUP.
Select the holder that you want to install. If you’ve purchased more
than 1, refer back to this page when you want to change the holder.
Press F4 for holder setup.
The holder setup is simple. You can follow the on screen
instructions as well as the steps on this page.
Engraving Table-
No holder installed
Tag Holder
Engraving Table-
With holder installed
This is the first screen
you will see. This is the
INTRODUCTION SCREEN.
Note: Holders can only be installed when you are in the HOLDER SETUP screen.
Attempting to install them at any other time could result in damage to the holders
or the machine.
H
OLDER
I
NSTALL
&
S
ETUP
Summary of Contents for VET TAG Engraver
Page 1: ......
Page 30: ...29 CLIPART...