Imagine VTM6801+, Installation And Operation Manual

Page: 31 / 52

VTM6801
+
Installation and Operation Manual 17
Chapter 3: Operation
See Figure 3-1 for the location of these controls.
Figure 3-1. Location of the DIP Switches and LEDs
During local control, when a DIP switch is down, its corresponding
LED is on. When a DIP switch is up, its corresponding LED is off.
During remote control, the LEDs are lit according to the settings that
are applied to the module. Jumper
J1 must be set to remote control in
order for you to control the module remotely. See “Setting the Jumper”
on page 12 .
S1 DIP switches S2 DIP switches S3 DIP switches
Gain 1 pot Gain 2 pot Gain 3 pot
J1 jumper
Module
Status LED
Channel 1 LEDs Channel 3 LEDs Channel 2 LEDs