Imagine communications NEXIO NX1010 series, Hardware Manual

Page: 52 / 56

Chapter 4
Troubleshooting
48
Replacing the
Boot Drive
If a boot drive is bad, a message appears indicating that there is a RAID
Access Failure (see
Figure 4-14 ).
Figure 4-14 RAID Access Failure Message
To remove the failed drive
1 Push the drive button (see Figure 3 ).
2 Pull the lever out (see Figure 3 ).
drive
button drive
lever
Figure 4-15 NX1010 Series Drive Replacement
3 Pull the failed drive out.
If your product has a different drive or you need help removing a drive,
contact Harris Customer Support.
4 Insert the new drive, and allow it to spin up.
The Rebuild process should begin automatically. If the Rebuild process
does not begin automatically, follow the procedure below to manually
start the Rebuild.
To manually start the Rebuild
1 During the system reboot (after the Memory Count appears), press F10 .
The MediaShield BIOS Array List appears.