11
HOW TO TURN ON THE POWER
Note: To prevent damage to the walking platform,
always wear clean shoes when using the treadmill.
Plug in the power cord (see
page 9). Next, locate the
reset/off circuit breaker on
the treadmill frame near the
power cord. Make sure that
the circuit breaker is in the
reset position.
Stand on the foot rails of the treadmill. Find the clip at-
tached to the key (see the drawing on page 10) and
slide the clip onto the waistband of your clothes. Next,
route the cord attached to the clip
under the handgrip
pulse sensor,
and insert the key into the console.
After a moment, the displays and various indicators will
light.
Important: In an emergency situation, the key
can be pulled from the console, causing the walk-
ing belt to slow to a stop. Test the clip by carefully
taking a few steps backward; if the key is not
pulled from the console, adjust the position of the
clip.
HOW TO USE THE MANUAL MODE
Insert the key into the console.
See HOW TO TURN ON THE POWER above.
Select the manual mode.
When the key is in-
serted, the manual
mode will be selected
and the indicator on the
Manual Control button
will light. If you have se-
lected a program, reselect the manual mode by
pressing the Manual Control button.
Start the walking belt.
To start the walking belt, press the Start button,
the Speed increase button, or one of the twelve
Quick Start buttons.
If the Start button or the
Speed increase button is
pressed, the walking belt
will begin to move at 1
mph. As you exercise,
change the speed of the
walking belt as desired by pressing the Speed in-
crease and decrease buttons. Each time a button
is pressed, the speed setting will change by 0.1
mph; if a button is held down, the speed setting
will change in increments of 0.5 mph.
If one of the Quick Start buttons is pressed, the
walking belt will gradually increase in speed until it
reaches the selected speed setting.
Note: The
console can display speed and distance in ei-
ther miles or kilometres. For simplicity, all in-
structions in this section refer to miles.
To stop the walking belt, press the Stop button.
The time will begin to flash in the Pace/Time dis-
play. To restart the walking belt, press the Start
button, the Speed increase button, or one of the
twelve Quick Start buttons.
Note: The first time the treadmill is used, observe
the alignment of the walking belt, and align the
walking belt if necessary (see page 27).
Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
Incline increase and de-
crease buttons. Each
time a button is pressed,
the incline will change by
0.5%.
Follow your progress with the matrix and the
displays.
The matrix
—When the
manual mode or the
iFIT.com mode is se-
lected, the matrix will
display a 1/4-mile track.
As you exercise, the in-
dicators around the track
will light in succession until the entire track is lit.
The track will then darken and the indicators will
again begin to light in succession.
5
4
3
2
1
Reset
Position
