7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet
from damage, place a mat under the treadmill.
6. Insert two Handrail Bolts (78) with Handrail Washers
(77) and Handrail Bushings (75) into the right Upright
(69) and the right Handrail Spacer (65). Turn the
Handrail Bushings so they fit against the Upright, with
the thick sides of the Bushings toward the center of the
treadmill, as shown in the inset drawing. Lift the right
Handrail (66) slightly and align the Bolts with the holes
in the Handrail. Next, thread the Bolts into the Handrail.
Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (78).
6
78
77
75
69
66
65
75
77
Thick
Side
5. Pull the Upright Wire Harness (98) up through the other
Handrail Spacer (65). Place the Handrail Spacer on the
right Upright (69) as shown, with the cutout turned to-
ward the treadmill (see inset drawing A).
Have a second person hold the Handrails (66) near the
Uprights (69) as shown. Connect the Upright Wire
Harness (98) to the wires extending from the Console
Base (81). See inset drawing B. Insert the connectors
and the Upright Wire Harness into the hole in the
Console Base (81).
Being careful not to pinch the Wire Harness (98), set the
Handrails (66) on the Spacers (65).
5
98 69
66
81
65
69
65
81
98
A
B
Cutout
4. Slide the Grounding Bracket (64) onto one of the Handrail
Spacers (65) in the location shown.
See inset drawing A. Pinch the tabs on the Grounding
Bracket (64) so that the tabs will fit into the hole in the
Upright (69 [see inset drawing B]).
See inset drawing B. Place the Handrail Spacer (65) on
the left Upright (69) as shown, with the cutout on the indi-
cated side. Note: Make sure that the tabs on the
Grounding Bracket (64 [see inset drawing A])) are in-
serted into the hole in the Upright.
4
Tabs
A
B
69
64
117
65
65
Cutout
7
