9
11. Press two Carriage Bushings (27) into the ends of
the Weight Carriage (22). Press two 50mm
Round Inner Caps (25) into the ends of the
weight tube on the Weight Carriage.
Insert an M10 x 20mm Bolt (26) into the bracket
on the Weight Carriage (22).
Slide the Weight Carriage (22) onto the Rear
Upright (2) as shown. Make sure that the
Weight Carriage and the Rear Upright are ori-
ented as shown.
12. Press a Carriage Bushing (27) into the top of the
Carriage Stop (28) as shown in the inset drawing.
Attach the Carriage Stop (28) to the indicated
hole in the Rear Upright (2) with an M8 x 70mm
Bolt (30) and an M8 Nylon Locknut (54).
Slide the Rear Upright (2) onto the bracket on the
Rear Base (3). Attach the Rear Upright to the
Rear Base using two M10 x 65mm Bolts (56),
four M10 Small Washers (6), and two M10 Nylon
Locknuts (11). Do not tighten the Nylon
Locknuts yet.
28
2
30
56
6
3
Bracket
Hole
6
11
54
12
27
28
22
26
27
27
25
25
Weight Tube
2
Angled End
11
13. Press a 50mm Square Inner Cap (10) into each
end of the Pulley Bar (53). Slide the bracket on
the Pulley Bar into the top of the Rear Upright (2).
Attach the Pulley Bar to the Rear Upright using
two M10 x 65mm Bolts (56), four M10 Small
Washers (6), and two M10 Nylon Locknuts (11).
Attach the Pulley Bar (53) to the Top Crossbar (9)
using a Support Plate (57), two M10 x 80mm
Bolts (41), and two M10 Nylon Locknuts (11).
Tighten all Nylon Locknuts (11) used in steps
1–13.
56
58
5
53
15
15
13
Ball
11
58
14
57
41
10
10
11
11
53
6
9
56
Bracket
2
14. Identify the High Cable (13), which is the shorter
of the two Cables. Route the High Cable up
through the indicated slot in the Pulley Bar (53).
Make sure the ball is in the indicated location.
Route the High Cable (13) around a Pulley (5) as
shown. Attach the Pulley inside the slot in the
Pulley Bar (53) using an M10 x 65mm Bolt (56),
two M10 Large Washers (58), two Pulley Spacers
(15), and an M10 Nylon Locknut (11). Do not
overtighten the Nylon Locknut; the Pulley
must be able to turn freely.
13
