Image Engineering
Seite
3
von
7
1 INTRODUCTION
With the iQ-FoV-Box, you have a chart illumination and positioning system optimized for resolution
measurements of high FoV cameras up to 180 degrees. Together with the iQ-Analyzer, it is a complete
automatic detection and analysis solution for two different chart setups. In the following manual, you will
find a detailed description of how to use this system to get the best measurement performance.
If you assemble your iQ-FoV-Box by yourself, please follow the separate installation manual.
Safety note: If the power supply gets interrupted or there is a power failure, the illumination may
execute a reset and start again with 1 % brightness.
2 STARTING THE SYSTEM
2.1 Placement
Place your iQ-FoV-Box in a dry condition and on even ground. Ensure that there is enough space around
the box. You need full access to the back door and enough space to adjust the alignment arm on the
front side to the full length.
2.2 Starting/Control overview
Connect the box to power and turn it on with the power switch placed on the control panel at the lower
left edge of the front wall of the box. On the right side of the control panel are the illuminance intensity
knob, the illumination on/off button, and a USB port. This USB port directly connects to the camera
mounting inside the box. You do not need to put a control or power cable inside the box.
The box is now ready for starting with camera and chart alignment. The alignment tools and chart setups
will be described in the following chapters.
3 CAMERA AND CHART ALIGNMENT
You can choose between two different chart setups when using your iQ-FoV Box. These setups will
allow you to analyze your images automatically with the iQ-Analyzer-X. For high performance, it is
crucial to align your camera inside the box and position the three different chart types in the correct
areas.
