EN
4
LOGIC MR16 DN S QRG Rev. 3
QUICK REFERENCE GUIDE
LOGIC MR16 TRIM Installation
The LOGIC MR16 TRIM (sold separately by Iluminarc) can be used to mount the LOGIC MR16 DN S flush to a ceiling or
overhead surface. To attach the LOGIC MR16 TRIM to the LOGIC MR16 DN S, insert the LOGIC MR16 DN S into the
top opening of the LOGIC MR16 TRIM until it snaps into place.
To remove the LOGIC MR16 TRIM from the LOGIC MR16 DN S, push the clip tab on the LOGIC MR16 TRIM down and
out while tilting the LOGIC MR16 DN S in the opposite direction until it comes free.
LOGIC MR16 TRIM Mounting
Before mounting this product with the LOGIC MR16 TRIM, read the
.
To mount the LOGIC MR16 DN S with the LOGIC MR16 TRIM attached, do the following:
1. Cut a 2.83 in (71.83 mm) hole in the ceiling or overhead surface to be used.
2. Route all cables necessary to that hole and plug into the LOGIC MR16 DN S before mounting.
3. Push and hold the spring arms on the LOGIC MR16 TRIM up and in.
4. Insert the LOGIC MR16 DN S into the hole until the spring arms are through.
5. Release the spring arms and push the product the rest up the way up. The tension of the spring arms will hold the
product flush to the ceiling or overhead surface until it is intentionally removed.
•
The maximum ceiling thickness which the LOGIC MR16 TRIM can support is 0.866 in (22 mm).
•
The LOGIC MR16 TRIM fits into a hole with a diameter of 2.83 in (71.83 mm).
Rotate and tilt as desired
Spring arm (x2)
Clip tab
2.83 in
71.83 mm
0.866 in
22 mm
!
