SWIFT K11-EN, Rev.A
76
9.2 Splice
Error message is displayed on the screen.
Refer to the [Error message list].
Splice loss is high or irregular.
Clean V-Groove, V-Block, reflector and object lens by referring to [Maintenance
of splice quality]. Replace electrode by referring to [Electrode replacement].
Refer to the “High estimated loss” from [Error message list].
If optical fiber warps or is bent, place the optical fiber’s bent direction to face the
bottom. Splice loss varies depending on cutting angle, discharge condition and
cleanliness level of optical fiber. Splice loss is still high or irregular even after
implementing the above recovery measures, contact to Ilsintech. Annual
maintenance is required to keep splice quality.
Monitor is suddenly turned off.
Refer to [Monitor sleep mode menu].
Power is suddenly turned off.
Refer to [Splicer sleep mode menu].
Either discharge amount or discharge time cannot be changed.
On SM, NZ, MM or AUTO mode, either discharge amount or discharge time
cannot be changed. Implement [discharge amount calibration], and the discharge
amount on these modes is properly maintained. When used on another mode,
discharge amount and discharge time are automatically set to prevent their
alteration.