illy Y1.1 Touch, Instruction Manual

Page: 20 / 112

20
Insert the capsule as shown in the picture.
Lower the movable part of the top of the machine completely,
and press the lever “A” until you hear it lock in place.
Position the cup on the cup stand “H”.
Start
Press (one button only):
- the button to brew an espresso coffee.
- the button to brew a long espresso.
When the coffee has reached the programmed level in the cup,
brewing will stop automatically .
Note: The pre-programmed volume for each button has
been set with the aim of satisfying the majority of users.
The brew setting for each button can be adjusted accor-
ding to personal taste by following the instructions in the
paragraph below.
Warning:
The capsules are single-dose and cannot be used to make
two coffees.
Remember to clean the drip tray “I” and empty the used
capsule container “G”.
Remember to change the water in the tank frequently.
ADJUSTING THE QUANTITY OF
COFFEE IN THE CUP
The machine allows you to set the desired quantity/volume of
coffee in a cup for both brew buttons
and .
Note: for the sake of simplicity, we will illustrate only how to
program the espresso button
; to program the long coffee
button you must carry out the same steps, but press the
latter button and use a suitably sized mug.
To adjust and program a personalized quantity of coffee to
be brewed, proceed as follows:
- Insert a capsule in the compartment “B”.
- Place an espresso sized cup on the cup stand ”H”.
- Touch the espresso button and keep it pressed
until reaching the desired quantity of coffee. Then release
the button. The machine is now programmed; the next time
you press the espresso button
the machine will brew
the quantity you have just programmed.
The programming replaces the factory settings.
MANUAL STOP
You can stop brewing coffee before the automatic stop by
again pressing the button you just selected.
Warning: in any case brewing will stop automatically after
a preset maximum time of about 70 seconds. In this case,
coffee could overfl ow from the cup.