6
ISP389B User Guide
7
ISP389B User Guide
Customer Helpline Number: 0844 481 5000
Set up
Setting up your 2.1 Channel Home
Music system
1
Plug one end of the power cable into
the socket on the rear of your unit
as shown.
2
Plug the other end of the power cable
into a standard three pin wall socket
and switch the power on at the wall.
The display will illuminate to read 12.00.
replace the battery
To change the batteries follow the
steps below.
1
Remove the battery cover from the
back of the remote as shown.
2
Insert the batteries as shown.
3
Replace the battery cover.
02
Setting the time
With the music system off, press the
Clk
ADj
button on the top of the system or
on the remote control for 3 seconds.
When the hour digit begins to blink on
the LCD Display, use the
Hr/MIn
buttons
on the top of the system or the
and
on the remote to adjust the hour.
1
battery backup for your 2.1 Channel
Home Music System
You will need to insert 2 AAA (not included)
batteries as described below.
1
Remove the battery cover from the
bottom of the Home Music System.
2
Insert the batteries as shown. Make
sure you place the batteries in with
the positive (+) and negative (-) ends
the correct way round.
3
Replace the battery cover.
2
1
2
Note:
Remove the plastic
sheet before
operating the
remote control.
the remote control battery
The remote control comes with a CR2025
button cell battery. The battery is already
inserted into remote control and blocked by a
plastic sheet.
To set the minutes press the
Clk ADj
button again and the minute digits will
begin to blink. Use the
VOluME/Hr/MIn
buttons on the top of the system or
the
and on the remote to adjust
the minutes.
