17
switches off after 2 hours).
PAUSE
Activation of the pause function
When at least one hob zone is functioning, the heating elements can be deactivated by
pressing the Pause key.
The pause display has priority.
The timers that have already been programmed (also for the independent timer) are stopped
and do not function during the pause time. The automatic heater and booster are also
deactivated on all the hob zones during the activation, while the calculation of the residual
heat and the limitation of the operating time continues to function without being stopped.
The LEDs of the other functions (timer) remain on depending on their status.
The pause can last up to 10 minutes. If it is not terminated within this time interval, the
command is deactivated. The hob zone can be switched at any time by means of the On/Off
key. Any active pause functions are in this way terminated.
Termination of the Pause function
To terminate the Pause mode and start the operation again, the Pause key and any other
key (not the same key again) must be activated within 10 seconds.
In this way the function existing before the Pause is re-established. If no other key is activated
within the 10 seconds, the hob zone is also switched off.
Additional functions of the pause LED
The indicator light behaves in the following way:
When the Pause function is deactivated, the LED remains off. When the pause function is
activated, the LED remains on. The LED flashes during the waiting time before a second key
is pressed. The LED also flashes if the supplementary recall function is possible after restart.
Recall (optional for the multifunction key)
The settings can be quickly recovered after power-off by means of the power key, the
operator has 6 seconds to activate the Pause key. This function can only be performed if it
was previously active and
was confirmed by an acoustic signal of the key.
The following operations are restored:
– cooking level of all hob zones
– minutes and seconds of the programmed hob zone timers
– switching conditions of the external circuits (guaranteed by the reminder function of the
external circuit)
– heat-up function
The following operations are not restored:
– limitation of the timer time (the operator deactivated it)
– timer operating cycle (a new cycle is started after restart)
– If the delay time of a power reduction is running when switching off (power management),
but the new cooking level has not yet been detected, the recall may not restore the last
setting of the operator (to be executed as a priority). This particular case can only occur
