Customer Support: 1-888-999-4215
11
CD, FM Radio & Line In
Programming a CD
1. Press the Stop button to stop the CD during play.
2. Press the Prog/Mem button on the remote.
3. Use the Skip/Tune buttons to enter the desired track number, then press the Prog/Mem button
to set the next track.
4. Repeat step 3 until the desired number of CD tracks are programmed.
5. Press the Play/Pause button on the remote to begin playing the programmed tracks.
Programming Radio Station Presets
1. With the radio on, tune to a desired frequency and press the Prog/Memory button once on the
remote or the unit.
2. Press the Tune+/- buttons on the remote to select a preset number.
Up to 20 stations may be preset.
3. Once you have selected the preset number you wish to program, press the Prog/Memory button again
to save the current station to that preset.
Tuning to a Saved Preset Station
1. In FM Radio mode, press the Repeat/Mem+ button to cycle through saved presets.
Loading and Playing a CD
Note: This unit is not compatible with MP3 CDs.
1. Open the Disc door.
2. Load a CD or CD-R/RW disc into the player, label side facing up.
3. Close the Disc door.
4. Press the Source button to set the unit to CD mode. Press the Play/Pause button begin playing music.
Playing the FM Radio
This unit is equipped with an internal FM antenna. To improve radio reception, adjust the position or location of the
unit and increase the distance between the speakers and the amplifier.
1. Set the Source to FM mode.
2. Use the Tune +/- buttons to tune the radio. Press and hold to rapidly seek through the frequencies.
Using the Line In
Requires a 3.5 mm audio input cable (not included).
1. Plug one end of a 3.5 mm audio input cable into the Line In input on the rear of the unit, and plug the
other end of the cable into the audio output on an MP3 Player or other audio source.
2. Set the Source to Line In.
3. Audio played through the connected device will be heard through the speaker. Use the controls on the
connected MP3 player or other audio source to play your audio through the unit.
