Setting the Clock
1. With the unit off, press and hold the MEM/Clk button until the display begins flashing.
2. Press the tun ± buttons to adjust the time in hours.
The PM indicator will light when the
hour is set in the PM.
3. While the display is still flashing, press MEM/Clk again to switch to minutes, then press
the tun ± buttons to set the time in minutes.
4. Press MEM/Clk to finish, or wait for the display to stop flashing.
Saving a Station as a Preset
1. With the radio on, tune to your desired frequency, press and hold the MEM/Clk button
until the screen flashes.
2. Press the tun ± buttons to choose the desired preset station, 1 though 20.
3. Press MEM/Clk again to set the frequency to that preset station.
4. Once set, press MEM/Clk to select your presets (Pxx will apear on the display), then
press the tun ± buttons to cycle through your preset stations.
CloCk
raDio
linE in anD BluEtooth
Radio Reception
An FM antenna is built into the clock radio. To improve FM radio reception, adjust the position
of the clock radio.
Tuning the FM Radio
1. Power on the radio by pressing the Power button.
2. Press the Source button to select radio mode, then press the tun ± buttons to find the
desired radio frequency.
3. Press the Vol ± buttons to adjust the volume of the radio.
Line In
An auxiliary line in port is built into the rear of the unit and can be used to play media directly from
a mobile device using a 3.5mm audio cable (not included). To do this, simply plug the cable into the
line in port on the unit and on your device. Press the Source button to select au on the display, and
your music should be heard through the speaker.
Pairing a Bluetooth Device
Refer to the user’s manual for your specific device for instructions on pairing and connecting Bluetooth
devices. When pairing, the device should remain within 3 feet of the speakers.
1. Press the Source button to select bt on the display. A blue light above the display will
also indicate this.
2. Press the Pair button. The blue light will begin to flash quickly.
3. Using the native controls on your Bluetooth device, scan for and select iCB284 in your
Bluetooth settings to pair.
4. If your device requests a password, enter 0 0 0 0.
5. When successfully paired, the indicator will stop flashing and remain solid.
6. After initial pairing, the unit will stay paired unless unpaired manually by the user,
or erased due to a reset of the device.
7. If any pairing issues should occur, un-pair the unit on your Bluetooth device and
follow the above steps again.
