NOVA 2000
Operating manual - English
18
8.2
Replacing the light bulb
To replace the light bulb:
1) turn off the master switch and remove the mains plug.
2) remove the four screws which secure the glass cover.
3) unscrew the light bulb and remove.
4) install the new light bulb and replace the glass cover with the four screws.
8.3
Checking and replacing the fuses
The fuses should always be checked with a continuity measuring instrument (tester, ohmeter,
multimeter etc.) as a visible check may not reveal an electrical fault. Fuses must always be replaced
with others of the same type (rapid or delayed) and with the same Amps, as shown in the manual.
The NOVA 2000 key-cutting machine has two fuses:
3,15 Amps
rapid for machines with
230 Volt
6,3 Amps
rapid for machines with
115 Volt
placed in the inlet socket, to protect the key-cutting machine from sudden changes in voltage or short
circuits.
It is advisable to check the fuses if the machine is not activated by turning on the master switch. Proceed
as follows:
1) turn off the master switch (P) and remove the mains plug.
2) remove the fuse board with the aid of a screwdriver.
Fig. 15
fuse board
fuses
Summary of Contents for NOVA 2000
Page 1: ... D430548XA vers 2 0 Operating manual NOVA 2000 ...
Page 4: ......
