Ductwork
1.Attach the vent adapter to the exhaust opening
2.Connect the pipe to the vent adapter and seal the joint with duct tape. Make
sure it is completely air tight.
Electrical Wire
1.Connect the range hood to an outlet.
2.If hardwired is desired, cut off the plug and connect three wires (black, white,
green) to the outlet wires and cap with wire connectors. Connect the wires
according to color (ex: black to black).
Finish
1.Remove any protective film from the hood.
2.Before using, make sure that any accessories such as baffle filters are properly
installed where applicable.
3.Test the range hood to see if it is working properly.
THIS RANGE HOOD MUST BE PROPERLY GROUNDED.
MAKE SURE THIS IS DONE BY A QUALIFIED ELECTRICIAN
IN ACCORDANCE WITH ALL APPLICABLE NATIONAL AND
LOCAL ELECTRICAL CODES. BEFORE CONNECTING
WIRES, SWITCH POWER OFF AT SERVICE PANEL AND
LOCK SERVICE PANEL TO PREVENT POWER FROM BEING
SWITCHED ON ACCIDENTALLY.
IKB02 SERIES INSTALLATION
Custom Hood Preparation:
1.The custom hood frame must be designed according to the shape and the
weight of the insert. Refer to Measurements and Diagrams
2.A sturdy base (3/4 inch thick plywood recommended) is needed to sustain the
weight of insert.
3.Please install the insert hood left & right stud support (not included)
4.Determine and mark the centerlines on the base of the wood frame where the
insert will be installed.
5.Determine the proper location for the Power Supply Cable. Make a wiring access
hole using a drill bit. Install the wire cable and seal the gap around hole.
6.Cut out the opening where the insert will be installed. (Figure 1)
1
·
9
·
·
10
·
