Engaging the augers
To engage the augers and start throwing snow, squeeze the auger control against the handle. Release to stop
the augers.
Stopping the engine
1.
Run the engine for a few minutes before stopping to help dry off any moisture on the engine.
2.
Move the throttle control to the STOP position.
3.
Remove the ignition key. Removing the key will reduce the possibility of unauthorized starting of the
engine while the equipment is not in use. Keep the key in a safe place. The engine cannot start
without the ignition key.
4.
Wipe any moisture away from the controls on the engine.
ADJUSTMENTS
Shave Plate
To check the adjustment of the shave plate, place the machine on a level surface. The wheels, shave plate
and augers should all contact the level surface. If the shave plate is adjusted too high, snow may blow under
the housing. If the shave plate wears out excessively, or the snow thrower does not self-propel, the shave
plate may be too low and needs to be adjusted.
Note:
On new snow throwers or machines with a new shave plate installed, the augers may be slightly off the
ground.
To adjust the shave plate:
1.
Drain the gas from the snow thrower.
2.
Pull the recoil starter handle until resistance is felt.
3.
Tip the snow thrower back so that it rests on the handle.
4.
Loosen the four lock nuts and bolts that secure the shave plate to the housing. Move the shave plate
to the desired position and retighten the nuts and bolts securely. See figure 14.
Figure 14
5.
Tip the snow thrower into the operating position and pull the recoil starter handle to test if it is difficult
to pull. If it is difficult to pull then remove the spark plug, pull the handle several times to ensure
trapped oil in the head is removed.
