5.
Re-tighten the 1/16” set screw until it stops. DO NOT
over-tighten.
6.
Line up the tab of the male connector with the female
connector coming out of the housing bulkhead and push
gently together. The tab will click into place when properly
connected.
7.
Move the Male Connector Wire to the left and out of the
way of the Port Hole Opening.
Connecting Your Camera
1.
Install your camera in the housing using the camera
mounting tray.
2.
Orient the hotshoe so the “LOCK” insignia is facing you
and the wire is coming out of the back of the hotshoe.
3.
Slide the hotshoe into the camera’s hotshoe mount.
4.
Push the back of the hotshoe forward firmly until it stops.
This will ensure a good connection. Failure to push
the hotshoe far enough forward may result in lack of
TTL or failure to fire strobes.
5.
Rotate Hotshoe Locking Ring clockwise to tighen
hotshoe. DO NOT overtighten.
Setting your Strobes
Your Ikelite DS strobe must be set to TTL for TTL exposure
with this kit. Any flash EV compensation set in the camera
will be added to or subtracted from the flash exposure.
Use of manual power settings will provide manual flash
exposure.
Limited Warranty
This Ikelite product is warranted against any manufacturing
defects for a period of one (1) year from the original date
of purchase. To obtain warranty service, the product must
be returned to Ikelite postage paid. Ikelite will, at its sole
discretion, repair or replace such products, and will return
to customer postage paid. All other claims of any nature are
not covered. Except as mentioned above, no other warranty
expressed or implied applies to this Ikelite product.
46040_Sony-ST1K-Alpha-TTL-Kit_-1217
LOCK
Male Connector Tab
Male Connector Wire
Port Hole Opening
Turn set screw
clockwise to
secure electronics
Hotshoe Locking Ring
Female Connector
