15
5.
Use your hand to gently flush away any small bubbles that may be
on the face of the lens port. Bubbles will produce soft focus spots in
your photo or video.
Installing an Accessory via the Accessory Port
1.
Remove the Hole Plug using an 11/16” open end wrench.
2.
Check the accessory fitting o-ring sealing area. Check o-ring and
housing o-ring sealing area. All should be clean and free of hair,
sand, or other debris.
3.
Lightly lubricate o-ring with Ikelite lubricant. Use ONLY Ikelite
lubricant. Other manufacturer lubricants can cause the o-ring to
swell.
4.
Carefully screw in and tighten accessory fitting. The accessory port
features a 1/2-20 threaded hole. Make sure your fitting is the same
thread pattern. DO NOT cross-thread. DO NOT overtighten.
5.
After installing an accessory, pressure test the housing by diving
without a camera inside.
NOTICE: Your Ikelite housing warranty DOES NOT extend
to cover the attachment of aftermarket housing accessories or
accessory fittings by 3rd parties. Warranty DOES cover factory
optional accessories attached by certified Ikelite service technicians.
»
Do not remove the Accessory Port Hole Plug unless you are
installing a compatible accessory.
